Implants for osteosynthesis - Implants for osteosynthesis. Specification for staples with parallel legs1 Scope and field of application This International Standard covers general requirements and the designation of dimensions and tolerances of staples with parallel legs intended for use in orthopaedic surgery. NOTE The annex gives guidance on the selection and use of staples and does not form an integral part of this International Standard.

Characteristics and requirements which are applicable to all three materials (ABS

Devices can be equipped with a range of paper feed and finishing options either directly connected to the computer system or via a network

Note: For example

To ensure objectivity for test equipment suppliers

Manufacturers of clay masonry bricks

Who is ISO 1920‑4 for

It supports the application of standards and reports on environmental management

It is assumed that the calibration data are fit for purpose and thus the treatment of outliers is not considered

Type 1: metal fuel tanks

system and associated controls for building commissioning

It enables you to routinely monitor many tool process parameters fewer charts

BS EN 60191-6-19 on Mechanical standardization of semiconductor devices is useful for: