End mill holder Whistle-Notch BT 40 - 06 - 50Application: For mounting straight shank tools and inclined flat according to DIN 1835 form E (Whistle Notch). Delivery: With clamping screw and axial adjustment bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine

Individual serial numbers on each block

Warranty : 1 year in normal statement

154 x 54 x 17

break-proof and impact-resistant ABS plastic

d = 40/d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079

For mounting tools with straight shanks

Bolt and Holding ring

With adjustable spray nozzle and shim

- Calibration of the angular position of spindles of milling-turning centres

For right-hand and left-hand threads

Wherever reduced interference contours are required

- Absolute/incremental measurement