Rubber hose and hose assemblies for oil suction and discharge service. Specification1 Scope This International Standard specifies the characteristics of four types of oil suction and discharge hose assemblies used for the conveyance of petroleum, including crude oils and other liquid petroleum products. Each type being divided into three classes depend on the aromatic contents. It is not suitable for liquefied petroleum gas and natural gas. Hose assemblies to this International Standard can be used in the temperature range 20 C to 80

it specifies the type of information to be provided by the manufacturer on safe working practices

The main aim of BS 6949 is to provide best industry requirements for bitumen-based coatings to ensure they offer adequate corrosion protection and waterproofing

BS 4073  also provides guidance on general requirements

The test is applicable to textile fabrics of full width

impacts are applied to the lubricating grease so that only very stable lubricating greases will perform acceptably

the other effects of the nuclear explosion: blast

It also gives the instructions that prove to be helpful to the users

DD IEC/PAS 62437 gives additional information for the use of active antennas for radiated emission measurement according to CISPR 25

supplied in either tile or roll form for manufacturing which helps you to offer an enormous quality homogeneous floor covers to consumers

general aspects) and the Annexes (taxonomy

and overall sensitivity for measuring the overall performance of hand-held probe Doppler foetal heartbeat detectors

2 which may have had an influence on the result