Coil Spring / Tie Rod Sleeve / Stabilizer Bar KitThe two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspensions SB004 front sway bar was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy wall 1. 25 inch

they are bent to follow the contour of the vehicles floor board

at degrees C 56 at neg 25

UMI’s rear upper control arms are high-quality

This kit combines both front and rear setups into one package

with additional mounting hardware available for purchase if needed

With the Parilla Leopard

25" axle tubes commonly found on early Moser 9” rear ends (manufactured before 2002) and other custom housings

1 EA VRF498GB-500 Rear Coilover Kit

Features:- Upper Panhard Bar Built using 1

and provide precision handling

s K-members give you a lightweight

DOM steel tubing