End mill holder Weldon SK 50 - 12 - 63Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Note: From d = 25 on two clamping screws Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional

Standard type without safety clutch

(applicable up to 21 bar)

Toolholders suitable for induction-

01mm to the centre axis

With clamping screw and O-ring

Application:

Centering nut (Pair)

DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE

contact- and hot air shrink units

Betthöhe H: 0

for disassembling adaptor sleeves

Metallic sealed Collets for internal cooling (applicable up to 100 bar)